Setting The Heat Setting; Setting The Heating Time; Thermal Cut-Out; Frost Protection - Silvercrest SKD 2300 A1 Instrucciones De Servicio

All manuals and user guides at all-guides.com
RP74308 Konvektor LB5 Seite 43 Mittwoch, 16. Mai 2012 3:28 15
3. Press the "Reduce temperature" button 17
to lower the desired temperature to a
minimum of 5 °C (41 °F).
Selected specified temperature 20 is
shown in display 5.

6.3 Setting the heat setting

The appliance has three heat settings:
– 1,000 watts
– 1,300 watts
– 2,300 watts
1. Press button 25 repeatedly until the
desired heat setting is set.
Selected heating level 11 is shown in
display 5.
2. Press the fan button 15 to switch the fan
on or off.
If the fan is switched on, "Fan"
symbol 12 is shown in display 5.
Note: The fan might make a slight noise,
but it does ensure better circulation of
the heated air.

6.4 Setting the heating time

The appliance has a timer for setting the
heating time to between 1 and 15 hours.
The appliance switches off automatically
once the heating time has expired.
1. Press timer button 18 repeatedly until
desired running time 19 is shown in
display 5.
2. To switch off the timer, press timer
button 18 repeatedly until running time
19 is no longer displayed.
SKD 2300 A1

6.5 Thermal cut-out

For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch 9 to "0" to
switch off the appliance.
2. Check whether the air inlet 6 or outlet 4
is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly,
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.

6.6 Frost protection

To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating
level repeatedly until
25
protection" symbol 13 appears in
display 5.
As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7 °C (44 °F), the
automatically switches on at the highest
setting.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display 5 shows room temperature again.
2. To switch off frost protection, press the
button for selecting heating level 25
repeatedly until "Frost
symbol 13 in display 5 disappears.
have the
"Frost
heating
protection"
43