Lionelo Ruben Manual De Usuario página 8

2. Assembly instructions
Warning: This item can only be installed by adults
1.
Open the support tube towards the two sides of the main model and assist
model (by pressing down the buttons and at the same time pulling both
sides of the support tube outwards) (fig. 1).
a. Press the buttons
b. Unfold the supports according to the arrows
2.
Insert the front and back leg tube into the support tubes of main model and
assist model, and make sure the shrapnel inside the tube pops well (fig 2).
3.
Mount the seat frame on the shaft of the main model and assist model
using mounting screws, cap button and end plugs. Then try to pull out
the seat arm of the seat frame in order to make sure the installation is
correct (fig 3).
1. Head of the seat arm
2. Plum blossom button
4.
Insert the ends of the toy bar into the square holes on the left and right
davit arm (fig. 4).
5.
Install the mosquito net on the seat (fig. 5).
6.
Fix the shoulder tape (fig. 6).
a. Top
b. Bottom
c.
Draw the tape out from the top Then, draw it through the bottom.
Fasten the tape
Adjust the length of the shoulder and waist belt (fig. 7).
Slide the buckle left/right to adjust the length of the waist harness. Press the
buckle button to level the waist harness (fig. 8).
a.
side
Slide the buckle up/down to adjust the length of the waist harness (fig. 9).
ATTENTION:
Swing function: five swing speeds available. Press "+" to speed up or "-" to speed
down. The current swing speed is shown by five speed LED indicators (fig.10).
There are three time settings available. If you press the time setting button once,
the first indicator lights on and the swinging is set for the following 8 minutes.
EN
3. Cap button
4. End plug
b.
press side
‑ 8 ‑