Using The Features - Greenlee CMGL-10 Manual De Instrucciones

Using the Features

Automatic Power Off To extend battery life, the meter will shut itself off after approximately
30 minutes of inactivity. The only way to restore power is to press
HOLD. To disable this feature, press HOLD while turning the meter on.
MAX/MIN Holds the minimum or maximum value on the display. Press once to
hold the minimum value; press again to hold the maximum value.
Press again to exit this mode.
ZERO Finds the difference between two measurements. While taking a
measurement, press ZERO to set the display to zero. ZERO ∆ will
appear on the display. Take the second measurement. The value on the
display will be the difference between the two measurements. Press
and hold to exit this mode.
HOLD Press momentarily to hold the present value on the display. Press
again to exit this mode.
Frequency Filter Filters out unwanted harmonics and other unwanted signals, which
can interfere with measurements. To prevent this type of interference,
select the 50/60 Hz position; the filter will limit any signals that are
higher than 100 Hz.
To measure higher frequency signals, select the WIDE position.
8