Descargar Imprimir esta página

Fold / Unfold; Care And Maintenance; Maintenance - Baby Trend TJ68 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

FOLD / UNFOLD

TO FOLD STROLLER
CAUTION:
Do not allow
children near stroller while
folding.
20)
• Close the canopy as described in the
canopy section (step 10). Place the seat
in the furthest recline position.
• Pull the stroller backward several inches
to adjust the front wheels to the front.
• Fold the stroller by pulling both release
triggers (Fig. 20a) and push handle
toward the floor. Make sure the front
wheels lie flat, then secure the stroller
in the folded position by locking the fold
latch, located on the right side of the
stroller, over the rivet (Fig. 20b).
TO UNFOLD STROLLER
CAUTION:
Do not allow
children near stroller
while unfolding.
21)
• Unlock the release lever (Fig. 21a) and
unfold stroller frame by pulling upward
on the stroller handle until the frame
locks (Fig. 21b).
13
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
All manuals and user guides at all-guides.com
Fig. 20a
Fig. 20b
Fig. 21a
Fig. 21b

CARE AND MAINTENANCE

TESTING FOR PROPER WHEEL INSTALLATION
WARNING:
ALWAYS
check the double nut locking
system before each use to
ensure that the front wheel is
securely fastened to the frame.
22)
• Lift the front wheel off of the ground and
sharply strike the top of the tire (Fig. 22).
The wheel should not be loose or come off.
If you experience front wheel wobble that is
beyond what is normal for use while walking
or jogging you may have to adjust the front
wheel housing nut.
23)
• Remove footrest to access nut. You
can use a standard crescent wrench to
tighten the nut (Fig. 23).
DO NOT OVER TIGHTEN this can
cause damage to the wheel
housing.
FENDER
If adjustment or replacement is necessary:
24)
• Line up the front fender and press onto
the front frame assembly (Fig. 24a).
• Insert the 4 screws through the
underside of the front frame assembly
into the front fender's plastic tubes.
Tighten the screws only until snug (Fig.
24b).
DO NOT OVER TIGHTEN.
SEAT PAD
• To clean the seat pad, use only mild
household soap or detergent and warm
water on a sponge or clean cloth.
OTHER
• Check your stroller for loose screws,
worn parts, torn material or stitching on
a regular basis. Replace or repair parts
as needed.
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

MAINTENANCE

Fig. 22
Fig. 23
Fig. 24a
Fig. 24b
14

Publicidad

loading