Youin Paris Manual De Usuario página 7

Operation
Low voltage protection
Motor failure
Controller failure
7- Multi-function display area:
ODO - Accumulated mileage TRIP - Trip mileage VOL - Voltage
CUR - Current RM - Residual mileage T1, T2 - Race time
LCD display controls
The key operation is divided into short press and long press, as well as long press of
compound key. Short press is for quick and frequent operations, for example:
1. S+/S- the power support / speed gear needs to be modified when riding, press the
key for a short while.
2.
switch to the multifunction area to display data when riding, press the key for
a short while.
3. Short press, S- power support -1
4. Switching the speed display. Long press S+ to switch speed display mode
5. Eliminate Trip. Long press S- to eliminate Trip
6. Accompaniment mode:
If you press and hold the button CUR for 3 seconds, it will start the motor at a constant
speed of 6km/h to carry the bike effortlessly while walking next to it. Pressing the
brake will deactivate the accompaniment mode. Do not use it if we are mounted on it.
We recommend not to abuse this assistance, especially on long or very steep slopes.
Press for a short while to turn on/off the big lamp.
7. Turn on and turn off the LCD:
(1) In the shutting down state, long press
password is "0000", short press S+ or S- to add or reduce the password value, and
short press to switch the password position; After the password is entered, long
press CUR to verify the password. If the password is correct, it will enter the normal
interface directly; if the password is wrong, the 4 bit password will be cleared, waiting
to be re entered;
(2) If the display is working, long press
8. Switching the content of multi-function display area
Short press to switch the value of the multifunction display
9. Parameters setting:
Long press S+ + S- to enter the parameter setting interface, the parameters that
can be set include:
Wheel diameter (unit: inch), number of magnetic steel, liquid crystal brightness,
undervoltage point, etc.
Under the setting interface, the parameter values can be modified by short pressing
or long pressing S+ and, S-. When the parameter is modified, it will flicker. After
Brake power failure
Switch failure
to start up; After starting up, the 4 bit
to turn off the display.
7
ENGLISH