Taurus CROSSBACK ALL OVER Manual Del Usuario página 10

- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 3 to 4 hours are needed for a
complete charge of the batteryNever attempt to
over-charge the battery (although it is recom-
mended that the first charge of the battery be
of 5 hours in duration).
- Connect the charger to the jack using the
socket on the applianceThe socket is located at
the back part of the appliance(Fig 3)
- The pilot light will come on to indicate that the
charger is charging the battery.
- At the end of the time period specified above,
remove the battery from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is con-
nected to the charger.
CHANGE OF MOTORIZED BRUSH
- At the bottom of the brush you have to press
the button to unpin the brush(Fig.10)
- Choose the brush according to the needs of
aspiration:
- E-1 Bristles brush to use on carpets
- E-2 Powder brush to use on hard floors.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product's packaging has been
removed
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
- Connect the tube in the air intake and the brush
at the end of the extencion tube(D)
- To disconnect the extension tube of the
vacuum cleaner, press the release button of
accessories (K) and pull out(Fig.4)
USE:
- Turn the appliance on, by using the on/off
button(L)
- Turn the appliance on, by using one of the
speed selection buttons.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The folloring accessory is designed to inster
into handy vacuum cleaner and extention
tube(Fig5)
Accessory 2 in 1:
A-1 Brush for furniture or textile
A-2 Lance
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button(L)
- Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced
- Disconnect the hose from the vacuum cleaners
air intake(Fig.6).
- Disconnect the dust tank pressing the button
(B), remove the cyclone from the tank and
empty the dust continer(Fig.7)
CHANGING THE FILTERS:
- Dust tank EPA filter (efficient air filter that effi-
ciently retains spores, ash, sawdust, pollen...),
it is advisable to change it a least once a year
or after every 50 hours of use, or if its potency
diminishes remarkably
TO REMOVE THE FILTERS:
- Disconnect the hose from the vacuum cleaners
air intake(Fig.6).