How To Install The Optional Accessories; Attaching The Dust Collector - Metabo HPT SV 1813DA Manual De Instrucciones

English
NOTE
Movement of the sander may tend to become
unsteady after new sanding paper has been installed,
because of the new, coarse grain of the paper. This
can be avoided by slightly tilting the sander forward
or backward during sanding or polishing. Sander
movement will become steady as the sanding paper
surface becomes properly abraded.
HOW TO INSTALL THE OPTIONAL
ACCESSORIES
WARNING
To avoid serious accidents, ensure the switch is
in the OFF position and pull out the battery.
1. Installing the polyester buff or the polishing sponge.
Since the attachment is a hook-and-loop type as with
the sanding paper, the polyester buff or the polishing
sponge can be mounted by just pressing it onto the
pad (Fig. 14).

ATTACHING THE DUST COLLECTOR

External extraction system:
Connect a suitable extraction device.
Use a suction hose with vacuum adapter (A) or (B) if necessary.
Duct
16
Vacuum adapter (A)
Vacuum adapter (B)
Sander side
Dust collector hose side
Fig. 15
Polishing sponge
* Fitting Measure is for reference.
Polyester buff
Fig. 14
1-3/8" (35 mm)*
Dust Collector Hose
1-1/2" (38 mm)*
Dust Collector Hose
1-3/4" (44 mm)*
Dust Collector Hose