VONROC S4 LM505DC Traducción Del Manual Original página 17

make a second cut with a lower cutting height.
A higher cut height should always be selected for
the first cut of the season.
1. Pull the height adjustment lever (17) outwards
(away from the machine housing) as shown on
figure I.
2. Whilst holding the height adjustment lever (17)
in outwards position, push it forward or back-
ward to the desired cutting height.
3. Release the lever (17) and ensure it engaged in
the slot properly.
NOTE: There are 4 cutting height levels available:
35mm, 45mm, 55mm, 65mm
Adjusting the handle (Figure A, P)
When adjusting the upper handle (1) or
lower handle (14), ensure that the power
cable is not caught.
The upper handle (1) can be folded inwards, to store
the lawn mower in a more compact formfactor.
The lower handle (14) can also be folded inwards
for storage purposes, but it can also be adjusted
in several positions as shown on figure P. This way,
the lawn mower can be adjusted to the ideal height
depending on the length of the user.
Switching the machine on/off (Fig. A, N)
Before starting, put the product on a flat
surface free of high grass.
Clean the underside of the deck before
turning on the machine.
Keep your feet well away from the cutting
blade.
Do not tilt the product when starting the
motor.
1. Ensure the safety key (21) is inserted in the
designated spot on top of the machine housing,
behind the carrying handle (7).
2. To start the machine, press and hold the safety
button (3) and press the on/off switch (2).
Whilst holding the on/off switch (2), you can
release pressure on the safety button (3).
3. To stop the machine, release the on/off switch
(2) and wait until cutting blade stops rotating.
WWW.VONROC.COM
Operating the mower (fig. A, O)
Always ensure that a safe distance
(provided by the length of the long handles)
is maintained between the user and the
mower housing.
Be especially careful when mowing and
changing direction on slopes and inclines.
Maintain a solid footing and wear sturdy,
non-slip footwear and long trousers. Always
mow along the incline (not up and down).
For safety reasons, the lawn mower may not
be used to mow inclines whose gradient
exceeds 15 degrees.
Use special caution when backing up and
pulling the lawn mower. Tripping hazard!
Before use
• Make sure that the lawn is clear of stones,
sticks, wire or other objects that could damage
the product or its product.
• Do not cut wet grass because it tends to stick
to the underbody of the product, preventing the
proper discharge of grass clippings, and it could
also cause you to slip and fall.
• Never cut off more than one-third of the total
length of the grass for a healthy lawn. In the
autumn, lawns should only be cut as long as
there is growth.
• Slowly push the product forward, do not force.
• Mow in slight overlapping rows. The most effec-
tive hat all the lawn is cut without missing any
spots, as shown on figure O.
• Circle around flower beds. When reaching
a flower bed in the middle of the lawn, cut a row
or two around the circumference of the bed.
• Pay special attention when changing direction.
• Always mow along inclines (not up and down).
You can prevent the lawn mower from slipping
down by holding a position at an angle upwards.
• Select the cutting height according to the
length of the grass. Make several passes to
prevent that too much grass is cut at one time.
• Empty the grass box regularly.
Note: The operating time of the rechargeable bat-
teries and therefore the area in square meters that
can be covered with a single battery charge is largely
dependent on the state of the grass (e.g. density,
moisture, height, cutting height, etc.) and the mowing
EN
17