Publicidad
Idiomas disponibles
Idiomas disponibles
SAVE THESE
INSTRUCTIONS
WARNING!
DO NOT LEAVE VACUUM
UNATTENDED WHEN IT
IS PLUGGED IN AND/OR
OPERATING. UNPLUG UNIT
WHEN NOT IN USE.
DOUBLE INSULATED
This appliance is provided with double insulation. Use
only identical replacement parts.
Servicing for Double Insulated Appliances
A double insulated appliance is marked with
one or more of the following: the words
"Double Insulation" or "Double Insulated"
or the Double Insulation symbol. In a double insulated
appliance, two systems of insulation are provided
instead of grounding. No grounding means is provided
on a double insulated appliance, nor should a means
for grounding be added to the appliance. Servicing a
double insulated appliance requires extreme care and
knowledge of the system, and should be done only by
qualified service personnel. Replacement parts for a
double insulated appliance must be identical to the
parts they replace.
POLARIZATION
To reduce the risk of electric shock, this appliance has
a polarized plug (one blade is wider then the other).
This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
EXTENSION
CORDS
When using the appliance at a distance where an
extension cord becomes necessary, a 2-conductor
cord of adequate size must be used for safety, and to
prevent loss of power and overheating. Use TABLE A
to determine A.W.G. wire size required. To determine
ampere rating of your vacuum, refer to nameplate
located on motor housing.
Before using appliance, inspect power cord for loose
or exposed wires and damaged insulation. Make any
needed repairs or replacements before using your
appliance. Use only two-wire outdoor extension cords,
which have two-prong non-grounding-type plugs and
receptacles which accept the extension cord's plug.
When vacuuming liquids, be sure the extension cord
connection does not come in contact with the liquid.
NOTE: STATIC SHOCKS ARE COMMON IN DRY AREAS
OR WHEN THE RELATIVE HUMIDITY OF THE AIR IS
LOW. THIS IS ONLY TEMPORARY AND DOES NOT
AFFECT THE USE OF THE APPLIANCE. TO REDUCE
THE FREQUENCY OF STATIC SHOCKS IN YOUR HOME,
THE BEST REMEDY IS TO ADD MOISTURE TO THE AIR
WITH A CONSOLE OR INSTALLED HUMIDIFIER.
Volts
120V
Ampere Rating
More
Not More
Than
Than
0
-
6
6
- 10
10
-
12
UNPACKING
AND SET-UP
1. Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature which may
have been shipped in the tank.
2. Attach rear wheels and front casters following the
instructions and illustrations below.
3. Before replacing tank cover, refer to Dry Pick Up or
Wet Pick Up Operation in this manual to ensure you
have the proper filters installed and inlet deflector is
positioned correctly for your cleaning operation.
4. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
5. Insert long machine hose end with locking-nut into
inlet of tank and tighten. Do not over-tighten.
6. Attach the extension wands
(not standard with all models)
to the accessory end of the
hose. Twist slightly to tighten the
connection. FIGURE 1.
7. Attach one of the cleaning
accessories (depending on your
cleaning requirements) on the
extension wands. Twist slightly to tighten the
connection. FIGURE 1.
Total length of cord in feet
25
50
100
AWG
18
16
16
18
16
14
18
16
14
FIGURE 1
150
14
12
12
TABLE A
PAGE 4
Publicidad
Solución de problemas
