All manuals and user guides at all-guides.com
5.
Fit the mounting ring and speaker to the cut-out and mount with the supplied screws and
clips. Apply a small amount of
the grille adhesive at 4 or
more points around the edges
of the grilles and carefully,
but firmly, press the grilles
into place.
V.
Installation-
Tweeters
Choose mounting locations for
your Platinum Format Titanium
dome tweeters. Remember that for
the best performance, the tweeters
should be mounted as close to the
mid-woofers as possible, with an
unobstructed, direct path to the
listening area. Check for clearance
behind the tweeter mounting
locations, making sure the tweeters
will not interfere with any handles,
window cranks, door locks, or
brackets. If the tweeters are to be
mounted in the vehicle doors, check
the operation of all functions (windows, locks, and any other switches or hand cranks) to make
sure there is no obstruction. Be sure the mounting location and the drilling of screw holes for
mounting will not present a hazard to any wires, control cables, fuel lines, fuel tanks, hydraulic
lines, or other vehicle systems or components.
Surface or Angle Mount-
1.
and drill two 1/8"(3mm) mounting screw holes and a 1/4"(6mm) wire exit hole in the
Tweeter
Base Plate or
Mounting
Angle Housing
Screws
mounting surface. Mount the base plate or angle housing to the mounting surface with
the screws. Feed the tweeter's attached lead wires through the exit hole. Carefully, but
firmly press the tweeter back against the base plate or angle housing, matching the slots
on the bottom of the tweeter with the bayonet style mounting tabs on the base plate or
angle housing. Rotate the tweeter body to lock it into place. Connect speaker wire from
the crossover T+ and T- terminals to the tweeter lead wires, observing correct polarity.
Hex Head
Machine
Tweeter
Screw
Bottom
Flush Mount
Plate
Housing
4
Grille
Mounting
Screws
Speaker
Mounting
Ring
Mounting
Holes
Screw
Clips
Fig. 3- Rear Deck installation
Using the base plate or angle housing as a template, mark
Mounting
Surface
Retaining
Clip
Wire
Leads
Mounting
Surface
® ®
Ultimate
U l t i m a t e
Cut-out
Mounting
Surface
Fig. 5- Tweeter Surface
Wire
or Angle Mount
Leads
Fig. 6- Tweeter
Flush Mount
Hex Nut