Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
Flush Mount-
2.
the mounting surface carefully. The exact size of the hole should be 2 1/8"(53.8mm), and
it will be difficult to hide any mistakes. Cut out the mounting hole. Slide the tweeter into
the flush mount housing. Push the hex head machine screw through the center hole in the
bottom plate from the side with the hex recess. Make sure the screw head is seated in the
recess so it will not turn. Feed the wire leads through the exit hole in the bottom plate.
Press the bottom plate into the bottom of the flush mount housing and turn it to lock it in
place. Feed the wire leads through first, then press the entire assembly through the cut-out
hole in the mounting surface. Press the retaining clip onto the machine screw, and
tighten the hex nut on the screw until the entire assembly is firmly in place. Do not over
tighten. Connect speaker wire from the crossover T+ and T- terminals to the tweeter lead
wires, observing correct polarity.
Model
Size
Impedance
Frequency
Sensitivity
Power- RMS
Power- MAX
Cone
Surround
Tweeter
Frame
Magnet Cover
Crossover
Mounting Depth(In.)
Mounting
See the supplied warranty card for service information
Call 888-909-9988 for technical assistance.
I. Introduction
5
Using the flush mount housing as a template, mark the cut-out hole in
Specifications
PS65
6.5"/165mm
4Ω
50Hz-25kHz
92.5dB
80 Watts
160 Watts
HEATT™
Butyl
Titanium
Black Chrome
Rubber
2-Way, 12dB/Octave
2.6"
64mm
Ultimate
PS52
5.25"/133mm
4Ω
70Hz-25kHz
92dB
65 Watts
130 Watts
HEATT™
Butyl
Titanium
Black Chrome
Rubber
2-Way, 12dB/Octave
2.2"
54mm
® ®
Publicidad
