Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2. Hose at tank. (Fig. 6)
a. Release air pressure.
b. Inspect hose, if end is split or worn, cut off clean and straight just
above damaged area and reassemble as described below using
c. replacement hose clamp.
Note: Do not attempt to reuse original factory installed crimped clamp
d. Slide clamp on hose
e. Holding end of hose under hot water for approximately 3 minutes
will allow hose to slide on tank connector easier.
f. Slide clamp into position shown in (Fig. 6).
g. Tighten clamp until a snug fit is obtained. (Test for leakage by
pressurizing with plain water.)
Step 3. Where hose enters valve body.
a. Insert small blade screwdriver into notch and twist 1/4 turn to
separate valve body from valve head. (Fig. 7)
b. Slide valve body back along hose to expose connection of
hose with valve head. (Fig. 8)
c. Plastic sleeve must be tight on hose; if not grip sleeve firmly with
thumb and forefinger and push toward end of hose until snug.
d. If leakage is due to cracked or damaged hose, cut off behind
sleeve, remove sleeve with pliers as shown then cut
remaining hose off valve head hose fitting. (Fig. 9)
e. To reassemble.
(1a) Slide plastic sleeve over hose (larger end of tapered sleeve
toward end of hose). (Fig. 8)
(1b) Push hose fully on valve head fitting (soaking end of hose in hot
water first will make this operation much easier).
(1c) Push sleeve snugly on hose as described above.
(1d) Align valve body with valve head and snap together tightly. (Fig. 7)
Step 4. If leak is from any other area of valve, replace valve assembly using Kit.
Problem: Sprayer Nozzle Does Not Spray Or Is Missing ( Fig. 10)
Solution:
a. Clean nozzle.
b. Remove nozzle cap.
c. Clean nozzle body and cap orifice using a toothpick or broom straw.
d. Replace nozzle.
e. If damaged or lost, replace using parts from kit.
GENERAL SPRAYING HINTS
1. Mix spray solution as directed on container.
2. Spray in the cool of the day, never when wind is blowing.
3. Dress right...cover arms, legs and wear eye protection.
SPRAYING TIPS
1. Spray all around to catch trouble wherever
it may start.
2. High pressure for fine spray, lower for medium
and coarse.
3. Over spraying is harmful and wastes
expensive material.
4. Fine spray for flowers. Medium for shrubs and bushes.
Coarse spray for weeds.
5. Always be sure to wash and rinse your sprayer
after each time it is used.
2B
All manuals and user guides at all-guides.com
Position clamp head
away from tank neck
and handle.
Tank Outlet
Fig. 6
SCREWDRIVER
VALVE HEAD
NOTCH
1/4 TWIST
GRIP BODY
ALIGNMENT
NOTCH
Fig. 7
LARGE END OF
VALVE HEAD
SLEEVE
VALVE HEAD
GRIP BODY
HOSE
HOSE FITTING
PLASTIC SLEEVE
Fig. 8
PLASTIC SLEEVE
HOSE SHOWN
CUT OFF
SQUEEZE OFF
SLEEVE AS SHOWN
Fig. 9
Fig. 10
3
Publicidad
