Metabo HPT DH3628DD Instrucciones De Seguridad Y Manual De Instrucciones página 15

CAUTION
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult
your dealer or the metabo HPT Authorized Service Center.
Symptom
The dust extraction performance has
declined, or dust is leaking out of the
dust extractor system.
The position of the nozzle won't lock. The following incorrect steps were
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are subject to
change without prior notice.
TROUBLESHOOTING
Possible cause
The dust box is full.
The fi lter box is clogged.
The fi lter, brush cap, or nozzle seal is
cracked, damaged, or worn out.
performed:
The nozzle was set to the
desired position
The nozzle adjustment button
was pressed
Remedy
Empty the dust from the dust box and
clean the dust box.
Clean the fi lter.
Or, replace the fi lter with a new one.
Replace it with a new one.
Perform the following steps:
While pressing and holding the
nozzle adjustment button...
Set the nozzle to the desired
position
Release the nozzle adjustment
button
English
15