Bosch 30-300 Instrucciones De Funcionamiento Y Seguridad página 11

Battery charge
status indication
Flashing light +
audio signal
Continuous light
Flashing light
OPERATING AND STORAGE ENVI-
RONMENT
The device is suitable exclusively for operation
at enclosed work sites.
For proper operation, the allowable ambient
temperature should be between 0 °C and +45
°C (32 and 113 °F) at an allowable relative hu-
midity between 20 and 95 %, free of moisture
condensation.
Fig. 4
160992A3VR.indb 11
All manuals and user guides at all-guides.com
Meaning
With the utility clip 15, the tool can be attached
to a suspension device.
Battery Charging:
– Fasten the utility clip 15 to the tool by en-
Only 6 –8 more
screwdriving opera-
Depending on the tool's centre of gravity, ei-
tions possible.
ther the front or rear slots can be used.
Capacity no longer
sufficient for a new
screwdriving opera-
and the hook of the suspension device.
tion or the tool was
subject to overload.
The tool can no lon-
ger be switched on.
– Remove the bat-
tery and replace
with a fully charged
one.
The tool is over-
heated and out of
operation:
– Before restarting
the operation of the
tool, wait until the
flashing automati-
cally stops after a
short period.
– Press off the marking ring 17 with a thin
– Using snap-ring pliers, slide the snap ring
The two shell halves of the LED holder 12,
which enclose the worklight 13, can now be
adjusted to any desired position.
– Pay attention not to damage the worklight
– Enclose the worklight 13 again with the two
15
– Press the snap ring 18 and the marking ring
16
11
SUSPENSION DEVICE
gaging it into the fastening slots 16 (Fig 4).
Regularly check the con-
dition of the utility clip
Fig. 5
12
17 18
19
13
ADJUSTING THE WORKLIGHT
screwdriver blade, a knife, or similar (Fig. 5).
18 toward the rear onto the housing shell.
cable and, without kinking or bending it,
slide it into the cavity 19 intended for it in
the housing shell.
housing shells of LED holder 12.
17 back to their initial positions.
12
3/7/17 12:22 PM