Publicidad
Idiomas disponibles
Idiomas disponibles
4
Wooden
Ember Nut
Logs/Ember bed
Ember bed Mounting Post
5
Ember bed Light Bulb
Light Bulb Holding Spring
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the heater and away
from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a clean soft
cloth. Do not use brass polish or household cleaners as these products will damage the metal trim. Citrus oil-based
products can be obtained at supermarkets or hardware stores.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, we recommend periodic cleaning/vacuuming of the fan/heater.
• Make sure the unit is turned off and unplugged whenever you are cleaning the heater or fireplace.
A119
All manuals and user guides at all-guides.com
4. Turn nuts counterclockwise to loosen, remove and set
aside. Securely grab logs on left and right side and lift
log/ember bed assembly straight up. Once ember bed
has cleared the support bracket and threaded rods,
bring log/ember bed assembly forward and out of unit
and set aside in a safe place (Fig. 4).
5. Unhook light bulb spring clips from the bulbs, and
Pull
Pull
7
unscrew the bulbs (Fig. 5) After replacing the
bulbs make sure to replace the light bulb spring
clip.
Follow steps 1 through 4 in reverse order to
reinstall front frame assembly into your insert.
www.tsicustomerservice.com
Publicidad
