Harvia Nova SWA20U1XA Instrucciones De Instalacion Y Uso página 52

S-CO
Lighting
EN Ventilation
Control panel key lock
Factory Reset
5s
rST
OFF
ON
Fragrance channel (on top of the steam nozzle)
Add scent to the fragrance channel and it will feed the scent into the steam produced by the evaporator. Use only
scents intended for evaporator use. Follow the instructions on the package.
Remote use
Steam generator can be controlled remotely with MyHarvia application once the connection has been established.
Remote control is possible when "rc on" is displayed on the control panel.
Pre-set time setting (timed switch-on): If the device is set to start with the pre-set time function, it cannot be
controlled remotely. Once the the device is turned on, it can be turned off with the remote control.
Dehumidifying: when the heater is turned off remotely and dehumidifying is enabled, dehumidifying starts and
cannot be stopped remotely.
52
WIFI connection
Connect control panel to WiFi network by using the MyHarvia application. Change the setting with
the - and + buttons. See MyHarvia application for more detailed instructions.
OFF >The WiFi connection is off
(WiFi indicator light on the control panel is off ).
On > The WiFi connections is on
(WiFi indicator light is lit in the control panel).
COnn > Connect mode is active.
Press the MENU button. The control unit switches to standby mode.
Lighting of the sauna/steam room can be wired so that it can be controlled from the control panel.
(max. 100W/230 V ~). Switch the lights on / off by pressing the control panel button.
If there is a fan installed in the sauna/steam room, it can be turned on and off from the control
panel (max. 100W/230 V ~). Switch the fan on / off by pressing the control panel button.
Press and hold the steam generator and light buttons for three seconds. Key lock can be activated
only in standby mode. Key lock also prevents remote start.
When the control panel is in standby mode, press and hold the steam generator, lights, and fan
buttons for 5 seconds.
Status message rSt OFF is displayed. Press + to change reset status to ON
Press the MENU to perform factory reset