Descargar Imprimir esta página

ATOMSTACK Laser Engraver Manual Del Usuario página 21

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

e. After completing the above settings, click next to the the
settings of carving speed, carving energy and carving size.
Introduction of Setup Interface
There are engraving parameters
summarized by us in the TF card
attached to the machine for your
reference.
3. Engraving speed, engraving energy and engraving size Setting
a. recommending the engraving speed for 3000, this is the best
value for the engraving effect after repeated experiments, of
course you can increase or decrease the speed according to your
preference, faster speed will save the engraving time, but it may
reduce the engraving effect, slower speed is the opposite.
b. In the selection of the laser mode, there are two commands for
laser, M3 and M4, it is recommended to use the M4 command for
1bit litter engraving, and M3 command for other cases. If your
laser only has M3 instruction, please check whether the laser mode
is enabled in the GRBL configuration, please refer to the official
instructions of LaserGRBL for GRBL configuration.
c. Choose the engraving energy according to different materials,
d. Finally, set the size you want to engrave, click on the "Create"
button, all the engraving parameters has been set.
Speed recommendation 3000
Input appropriate energy
according to your material
Enter the appropriate size
according to the contour of
the object to be carved
Setting of engraving speed and laser power

Publicidad

loading