Dust Extraction - Tyrolit HCE150 Instrucciones De Funcionamiento Originales

HCE150
Fig. 5
Press the spindle lock button to lock the work spindle (see arrow – Fig.3).
Screw on the clamping screw and tighten it with the face spanner (see Fig.4).
Instructions for assembly:
• Regardless of the requested grove width, all spacer discs provided must always be mounted.
Otherwise, the diamond cutting disc can become loose during operation and lead to injuries.
• At least one spacer disc must be mounted between two diamond cutting discs.
• When mounting the diamond cutting discs, ensure that the direction of rotation arrows on the diamond cutting
disc match with the rotation direction of the machine (see direction of rotation arrow on the protective hood).
• Always replace the diamond cutting discs in pairs.
• Use only original accessory!
• The wall chaser is in power and speed optimal adjusted to the TYROLIT-diamond cutting discs.
Thus you reach the best work result in consideration of the material to be worked on (see accessories).
In order to check whether the spindle stop is released before you switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a safe position. If the machine does not run easily,
stop working immediately.
Information on Structural Calculations
11
Slots in supporting walls are subject to the Standard DIN 1053 part 1, or country- specific regulations.
These regulations are to be observed under all circumstances.
Before starting work, consult the responsible structural engineer, architect or the construction supervisor.
The permitted slot depth and width depends on the slot length, wall thickness and the building material used.
12

Dust Extraction

Dust which occurs during your work is hazardous to health. That is why the HCE150 must be used with a vacuum
cleaner, and a dust mask has to be worn.
A suitable wet/dry vacuum cleaner is available as accessory. It can directly be attached to the connection on the
dust hood.
Fig. 6
First the wheel flange has to be mounted on the work spindle (see arrow).
The wheel flange with its driving must have a correct seat on the work spindle.
Then mount one of the two diamond cutting discs.
After that put the spacer discs and the second diamond cutting disc according to
the required groove width on the work spindle.
To securely fasten the suction hose, it can be secured against slipping out using the hose
fixation.
en
23