Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Remove two (2) Phillips screws from the lint screen as shown
in below figure.
5.
Lift the front panel assembly up off the tabs and away from
the dryer. Route the door switch harness around the front
console bracket.
Removing the Belt and Drum
1.
Disconnect Moisture Sensor connector.
2.
Remove the four (4) 1/4" hex-head screws from the lint duct
as shown in below figure. Swivel the lint duct down from the
bulkhead and remove.
3.
Remove the four (4) 1/4" hex-head screws securing the front
bulkhead to the side panels. Lift the bulkhead up off the side-
panel tabs and remove (refer below figures).
9
Publicidad
