Descargar Imprimir esta página

Remington HC9700 Manual Del Usuario página 6

Ocultar thumbs Ver también para HC9700:

Publicidad

ENGLISH
TAPER LEVER
The taper lever settings can be seen on the table below.
Setting one gives you the length indicated on the fixed comb you are using.
Using the taper lever will increse this length correspondingly.
TO ATTACH A COMB
Hook front side of attachment comb on front side of teeth.
Press back side of comb downwards, until the tab clicks into place.
TO REMOVE THE COMB
Press upward on the tab to release the comb.
With tab released, pull comb away from clipper and unhook front of the blade.
INSTRUCTIONS FOR CUTTING HAIR
For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the first time, start with the maximum
comb attachment.
STEP 1 – NAPE OF THE NECK
Attach the 3mm or 6mm fixed comb
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – BACK OF THE HEAD
With the 12mm or 16mm guide comb attached, cut the hair at the back of the head.
STEP 3 – SIDE OF THE HEAD
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
Use the longer length fixed combs of 22mm or 25mm to cut hair on top of the head
against the direction in which the hair normally grows.
Always work from the back of the head.
6
Setting
1
2
3
4
5
Cut length
1.0
1.15
1.3
1.45
1.6

Publicidad

loading

Este manual también es adecuado para:

Rg012a