Publicidad
ENglISh
Step 5: (fig. 5)
1. Assemble the plugs (J) into the frame and slide the
flange bearings (I) onto the axle and secure in the frame.
Fig. 5
J
J
I
Step 6: (fig. 6)
1. Attach the hopper to the frame and support angles (AE)
using four 1/4 x 1-3/4" hex bolts (Q), washers (E) and
1/4" nylock nuts (F). Guide the impeller shaft through
the hole in the flow plate and hopper. Insert the hairpin
agitator (M) through the impeller shaft once inside the
hopper.
Fig. 6
M
Q
E
AE
F
4
Step 7: (fig. 7)
1. Attach the tube stand (AK) to the frame using two 1/4 x
2" hex bolts (A) and 1/4" nylock nuts (F).
Fig. 7
I
A
Step 8: (fig. 8)
1. Attach a wheel to the right side by sliding onto the
axle, a .531 washer (D), a plastic spacer (H), a wheel (X),
another .531 washer (D) and secure with a cotter pin (G)
by bending the ends out.
Fig. 8
G D
F
AK
G
H
X
D
Publicidad
