Publicidad
Idiomas disponibles
Idiomas disponibles
4. TECHNICAL CHARACTERISTICS
The temperature in the room where the indoor ventilation unit is installed must be between +1˚C and +40˚C, with up to 65% relative humidity (no
condensation). Disconnect the device if its use conditions are outside the specified limits.
Bring in fresh air through the windows.
The temperature of the air moved must be between -20˚C and +40˚C.
In terms of type of protection against electrocution, the device refers to Category II equipment.
Equipment protection rating against the penetration of solid and liquid bodies - IP22.
To ensure continuous improvement in the quality of our devices, ALDES reserves the right to amend any device details published in this document
at any time.
Speed
Power supply settings
Power consumption, W
Airflow, m3/h (CFM)
Rotation frequency, min-1
Acoustic pressure level at a distance of 1 m, dBA (Sones)
Acoustic pressure level at a distance of 3 m, dBA (Sones)
Street noise suppression, dB(A) (Sones)
Thermal efficiency %
The telescopic design of the air duct means that it can be adjusted for length without cutting it mechanically. The thickness of the wall in which the
ventilation unit can be installed based on the outdoor hood used is indicated in the table below.
Ventilation unit model
Nano Air 50
The technical characteristics of the concrete model are shown on the device's box label.
The overall and connection dimensions of the outdoor rain hood, the height of the air duct extension beyond wall A and the hood installation
procedure are given in the manual.
The front panel overall dimensions are indicated in the figure below.
Thickness of wall
CHARACTERISTIC
Model
Permissible wall thickness [mm]
240–425
I
100-240 V ~ 50/60 Hz
4.50
21 (12)
610
22 (0.4)
13 (0.2)
57
213
Nano Air 50
II
III
5.00
7.00
32 (19)
50 (29)
800
1450
29 (0.7)
32 (1.0)
20 (0.4)
23 (0.5)
40 (2.5)
up to 90%
80
240
EN
21
Publicidad
