Publicidad
Idiomas disponibles
Idiomas disponibles
3. Installation for 2-Way
Spacer
E-Ring
Missing Tooth
IMPORTANT! This valve is not intended to be used as a shut-off valve. If fewer than
three accessories will be installed, complete the 2-way conversion before plugging
any outlets.
IMPORTANT! The internal plug must be removed before installing the finished wall.
2-Way Conversion
Temporarily remove the plaster guard.
Rotate the detent until positioned vertically.
Verify that the missing tooth is oriented up.
Using a 1/4" hex wrench, remove and discard the internal plug from inside the
valve body.
Plug the unused port (left or right) with a 1/2 NPT plug (not provided).
Using pliers, remove the spacer from the detent.
Push the detent in. The points of the detent should engage the notches of the valve
cartridge.
Install the spacer between the detent and the E-ring.
1491214-2-A
Detent
Accessory #2
Water Line
Plaster
Guard
6
Accessory #1
Water Line
Internal
Plug
1/2 NPT
Plug
Kallista
Publicidad
