Instruction manual
• Joists, beams and rafters shall not be cut or
notched to install the appliance.
• Please do not install the appliance close to
curtains and other combustible materials.
This could cause a fire.
• The appliance shall, under no
circumstances, be covered with insulating
material or similar material.
• The heater must not be located immediately
below a socket-outlet.
• Do not use this heater if it has been dropped.
• WARNING: The heater must not be used if
the glass panels are damaged.
•
WARNING: In order to avoid
overheating, do not cover the heater.
• Use this heater on a horizontal and stable
surface, or fix it to the wall, as applicable.
• WARNING: Do not use this heater in small
rooms when they are occupied by persons
not capable of leaving the room on their own,
unless constant supervision is provided.
• WARNING: To reduce the risk of fire, keep
textiles, curtain, or any other flammable
material a minimum distance of 1m from the
air outlet.
4
• The heater needs to be installed so that the
switches and other controls cannot be
touched by a person in the bath or shower.
This product complies with conformity requirements of the applicable
European regulations or directives.
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
Authority or local store for recycling advice.
Installation
Foot assembly
• Before using the heater, the feet must be
fitted to the unit. (image 1)
• These are to be attached to the base of the
heater using the 8 ST4x12mm screws
provided. (image 2)