Arregui CI10 Manual De Instrucciones página 15

SURFACE ASSEMBLY INSTRUCTIONS
H
1. Calculate the position where you want to
install the lock, always inside the door. Place
the adhesive spacer (H) as shown in the image,
stuck to the body of the lock.
M
B
4. Once the base plate (B) and the shims (C), if
necessary, have been pre-positioned, drill and fi x
to the door using the screws provided (M).
E
I
6.B Position the bolt storage part (E) on the door
frame, fi xing it with an adhesive strip (I) at the
correct height to ensure the lock can be closed
and the door locked.
2.Next to the adhesive spacer (H), position the
bolt storage part (E) on the door frame. The
spacer marks the minimum distance between
the lock and the bolt storage part. If both these
parts are not at the same height, you must use
the shims (C) to wedge the lock as shown in
step 4.
B
L
5. Screw the body of the lock (A) to the base
plate (B) using the four screws provided (L).
E
M
7. Repeat the drilling process to fi x the bolt
storage part (E) to the door using the screws
provided (M).
Important: Check the lock
functions correctly, always from
inside the home.
I
B
3. Fix the adhesive strips (I) to the rear of the
base plate (B) or the shims (C) to suitably
position it on the door before drilling.
A
A
6_A. To adjust the bolts better, the (E) compo-
nent can be installed in two different positions.
With the bolts in the closed position, verify in
which position to install the piece. The bolts
must stay as close as possible to the edge of (E)
to avoid play when opening the door.
E
1
8. Press the trim (E1) into place.
En

E