Using The Control Panel - Tristar DH-5419 Manual De Usuario

• Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the
local voltage before connecting the device. Voltage 220V-240V
50Hz).

USING THE CONTROL PANEL

• Power - Touch once to switch the appliance on, touch again to
switch the appliance to standby.
• Power indicator – Illuminates when the appliance is plugged in.
• Plus and Minus – Touch the + or – icons to increase or
decrease the time between 01-24 hours or to adjust the humidity
level between 40% and 80% with 5% intervals.
• Fan Speed - Touch to switch between HIGH and LOW fan
speeds.
• Fan speed indicators – Indicates the selected fan speed.
• Humidity – Touch to change the humidity level then use the +
and – icons to increase or decrease the humidity level between
40% and 80% with 5% intervals.
After operating for a period in an environment where the humidity
level is 2 % lower than the selected humidity level, the compressor
will stop then the fan will continue to run for 3 minutes before
stopping. When the humidity of the environment is equal to or higher
than the selected humidity by 2%, the compressor will restart after 3
minutes.
Instruction manual
EN
7