Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Adapter
Waterway
Mounting
Screw
Sprayhead
IMPORTANT! Do not discard any removed components.
IMPORTANT! Do not tighten the setscrews. They will need to be adjusted to complete the installation.
‰ Using a 5/64" hex wrench, turn each setscrew clockwise until the screw stops.
‰ Tilt the sprayhead up to remove the sprayface from the assembly.
‰ Remove the nozzle membrane, being careful not to tear membrane.
‰ Using a 5/32" hex wrench, remove the hex screws and set aside.
‰ Remove the sprayhead. Verify that the two sealing rings are still attached.
‰ Using a Phillips screwdriver, remove the mounting screw.
‰ Pull the waterway from the adapter.
1506293-2-A
6 of 23
4. DISASSEMBLE THE SPRAYFACE
Sealing
Ring
Setscrew
Hex
Screw
Nozzle
Membrane
Sprayface
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Bodyspray
Tilt sprayface up
to remove from
sprayhead.
Publicidad
