Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Attach the Sprayhead
Ribs
Groove
Attach the Sprayhead
‰ With the ribs of the sprayhead facing up, install the sprayhead to the waterway.
‰ Using a 5/32" hex wrench, secure the sprayhead to the waterway with the two hex screws provided. Do not
overtighten.
‰ Verify the sprayhead moves freely up and down.
‰ Place the nozzle membrane over the sprayhead.
‰ Align the long edge of the membrane with the rib-side of the sprayhead.
NOTE: For optimum performance, ensure the membrane is applied evenly.
‰ Applying pressure evenly, press the membrane seal into the sprayhead groove.
Attach the Sprayface
NOTE: For products with brushed finishes, align the brushed patterns of the sprayface and the escutcheon in
the same direction.
‰ Tilt the sprayhead down to expose the ribs on the top.
‰ Position the grooves of the sprayface over the ribs of the sprayhead.
‰ Press the sprayface down to cover the sprayhead, as illustrated.
‰ Tilt the sprayhead up to expose the holes on the bottom.
IMPORTANT! The setscrews must be flush with the edge of the sprayface. If the setscrews protrude outside of
the sprayface, product damage will occur.
‰ Using a 5/64" hex wrench, turn the setscrews counterclockwise until they are flush with the edge of the
sprayface.
‰ Turn on the main water supply and check for leaks. Repair as needed.
1506293-2-A
8 of 23
6. COMPLETE THE INSTALLATION
Waterway
Sprayhead
Hex Screws
Nozzle
Membrane
Attach the Sprayface
Finished
Wall
Ribs
Sprayface
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Bodyspray
Setscrews
Publicidad
