Power
consumption
standby
mode
condition
of
standby
(if
rounded
to
two
places
Power consumption in delay
start (Pds) (iff applicable)
rounded
to
two
places
Airborne
acoustical
emissions
The device meets the European standards and the directives in the current version at
delivery:
• LVD 2014/35/EU
• EMC 2014/30/EU
• EUP 2019/2022
NOTE: the above vaues have been measured in accordance with standards under
specified operating conditions. Results may vary greatly according to quantity and
pollution of the dishes, water hardness, amount of detergent, etc.
The manual is based in the European Union's standards and rules
3.
INSTALLATION
Installation of electrical connections must be carried out only by authorised
professionals.
POSITIONING AND LEVELLING
• Remove the device from all packaging and check that it has not been damaged
during the transport. If it is damaged, contact the seller and do not continue with
the installation process.
• Place the dishwasher in the desired location. Please refer to the features section
to find out if your device can be built in or freestanding model.
• Place the dishwasher on a level, sturdy floor. If the floor is uneven, the front feet
of the appliance can be adjusted until it reaches a horizontal position (the angle
of inclination must not exceed 2 degrees). If the appliance is correctly leveled, it
will be more stable and less likely to move or cause vibration and noise during
operation.
in
W
(Psm)
in
networked
applicable),
decimal
W
decimal
noise
dB(A) re 1
pW
-
-
1.00
1,00
49
49
-
1.00
49
50