NSK Primado2 Manual De Operación página 19

5-3 How to operate the Motor
This can be done in three ways: by the Motor with Hand Control, the Primado2 Wire Pin Driver or the Foot Control.
● The Motor with Hand Control and the Primado2 Wire Pin Driver can also be operated by the Foot Control. Connect it with
CAUTION
the Foot Control and depress the Pedal. The Motor will work in the normal mode of the Foot Control, regardless of the
Hand Control.
● If operating the Motor only with the Motor with Hand Control and the Primado2 Wire Pin Driver, it is recommended to
disconnect the Foot Control from the Control Unit. Alternatively, set the Foot Control to OFF by the Foot Control ON/OFF
Button (to disable the Foot Control).
● The Hand Switch of the Motor with Hand Control and the Pedal of the Foot Control are variable. The rotational speed
increases/decreases within the preset rotation range, depending on the extent/duration of depressing.
When using the Motor with Hand Control
(P200-HMH-HS, P200-SMH-HS, P200-BMH-HS)
1) Confirm that the Safety Lock of the Hand Control is OFF.
2) Slide the Adjustable Lever to the desired length.
3) Hold the Hand Switch and slide the Safety Lock to ON. (Fig. 20)
4) Depress the Hand Switch to start the Motor. When the Hand Switch is depressed or
released, there is a short alarm sound.
When the Reverse Mode has been selected, the Bur rotates in reverse. During the
reverse rotation in this Mode, the alarm continues to sound.
● When operating the Safety Lock, be sure to hold the lever with your finger. If operating it without holding the lever, the
CAUTION
lever might inadvertently be depressed when the Safety Lock is being turned ON/OFF, thereby triggering a rotation of
the Motor. This might cause an accident.
When using the Primado2 Wire Pin Driver (P200-WPD)
1) Confirm that the Safety Lock is working (
2) Release the Safety Lock of the Wire Pin Driver from LOCK (
Reverse OFF (FWD /
- In the Reverse OFF (FWD/
Pin Driver, the Attachment rotates forward. When depressing the Trigger or releasing
it, a short alarm sounds. In this Mode, the upper Trigger (A) is locked, and therefore the
Trigger cannot be depressed (i.e. it cannot be put into operation).
- In the Both ON (FWD/REV) Mode, when depressing the lower Trigger (B), the Attachment
rotates forward. When depressing the Trigger or releasing it, a short alarm sounds. When depressing the upper Trigger (A), the
Attachment rotates in reverse. During the reverse rotation, the alarm continues to sound.
- In the Both ON (FWD/REV) Mode, when depressing both the upper(A) and lower(B) Triggers simultaneously, the forward and reverse
rotations of the Attachment are repeated alternately (i.e., the rotation direction oscillates). The rotation direction changes at every
360 degrees of rotation. If one of the Triggers has been depressed earlier, it will take priority in the function and rotation direction.
When the other Trigger is depressed with the first Trigger already functioning, the forward and reverse rotations will start to alternate:
namely, Oscillate Mode will start.
Upper (A)
Lower (B)
Upper and Lower depressed simultaneously (A B)
● The Wire Pin Driver operates in the rotation direction set not by the Control Unit but by the Wire Pin Driver.
CAUTION
18
/ ).
) or Both ON (FWD/REV).
) Mode, when depressing the lower Trigger (B) of the Wire
Trigger
/ ) and switch it to
Rotation Direction
Reverse Rotation
Forward Rotation
Oscillation (Forward and reverse rotations are repeated alternately)
OFF OFF
ON ON
Safety Lock Safety Lock
Ａ
Safety Lock Safety Lock
Ｂ
Fig.20
Fig.21