Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE
HINTS
• When the subwoofer is switched on, all settings such as PRESET and EQUALIZER are loaded as they were
before the subwoofer was switched off. The subwoofer is ready for operation after a short time.
• After about 30 seconds without any input via the turn-push encoder, the display system exitsLevels in
the menu structure and the main display with the selection VOLUME is automatically displayed.
DISPLAY MAIN
In normal operation, the main display is activated, with the main menu, the set delay and the activated
preset being displayed. The Bluetooth status, the volume level (LVL) and the gain (VOL) are displayed
graphically.
If the top segment of the level display lights up red, this indicates that the input stage is being operat-
ed above the distortion limit (clip). Reduce the output level of the playback device (e.g. mixer) until the
clip segment no longer lights up and the subwoofer reproduces audio signals without distortion.
VOLUME
To adjust the level of the subwoofer, select VOLUME in the main menu off, confirm, then set the desired
value from -40 dB to +10 dB and confirm again.
mute: Press the encoder for approximately 2 seconds to mute the subwoofer and again for approxi-
mately 2 seconds to unmute (at all menu levels).
<
VOLUME
0
ms
105
LVL VOL
+0.0
<
VOLUME
0
ms
105
LVL VOL
+0.0
Hz
Hz
11
Publicidad
