Battery Charge Indicator; Storage And Cleaning - Braun ExactFit 1 Manual Del Usuario

To recall the reading, press and hold the power button
4 seconds while the unit is switched off. When all the display elements
are shown, release the power button and the screen will show the last
reading with an

Battery charge indicator

Batteries almost discharged
When the batteries are approximately 75%
used, a battery warning appears. This icon
blinks 3 times first when the device is turned
on, then goes to measuring mode. The
monitor will continue to measure reliably, but
new batteries should be obtained.
Batteries discharged—replacements required
When the batteries are fully discharged,
the battery symbol will flash empty along
with 3 short beep sounds as soon as the
device is switched on. You cannot take any
further measurement and must replace
the batteries. Refer to the section called
"Inserting batteries".

Storage and cleaning

•
ALWAYS keep the unit in the carrying case after its use.
• DO NOT put the item directly under the sunlight, in high temperature
or humid and dusty places.
•
DO NOT store in extremely low (less than -4°F (-20°C)) or high (more
than 131°F (55°C)) temperature.
•
Use a piece of cloth with water or mild cleansing agent to clean the
case and then use a piece of dry cloth to wipe it dry. Use a piece of dry
cloth to wipe the cuff when it is dirty.
•
NEVER use abrasive cleaning agents, thinners, or benzene for
cleaning, and NEVER immerse the unit in water or other
cleaning liquids.
•
When the unit is not to be used for a long time, remove the batteries.
(Batteries may leak or cause harm).
• DO NOT modify the device. NEVER open the device! This will void the
manufacturer's warranty.
• DO NOT use this device close to strong electromagnetic fields such as
mobile telephones or radio installations. Maintain a minimum
distance of 3.3m from such devices when using this unit.
6
symbol.
for at least
!