Ventilation Systems; Internal Components - AGV K1 Guia De Inicio Rapido

2) VENTILATION SYSTEMS

Polystyrene ducting
Front air vents
Chin air vent
Upper air extractor
Open
Close
1
3
2.4) Removing/fitting the nose guard
The nose guard can be removed by gently dislodging it from its seating. To refit, slide
the plastic flaps into position and make sure it is properly fastened.
12
2.1) Opening/closing the front vents
To open/close the front air vents, push the slider until you
hear it click which indicates it is locked in position (1-2).
Slider
2
2.2) Opening/closing the chin vent
To open/close the chin vent, raise/lower the mechanism
inside the vent (3).
2.3) Visor micro opening
To operate the visor micro opening system, push the
central slider on the chin guard upwards to open the
4
micro-opening system. Push downwards to close (4).

3) INTERNAL COMPONENTS

1
2 3
1 4
CLICK!
3
Crown pad
Cheek pads
Wind-proof chin strap protection
3.1) Removing/fitting cheek pads
To remove the cheek pads, hold them in front near the
chin guard and pull them in the direction of the arrow
to free them from the press studs (1). Slide the plastic
flap out of its position and remove the cheek pads (2).
To refit the cheek pads, slide them into the helmet and
2 fasten them into place with the press studs (3). Slide
the plastic flap into position
on the side of the helmet (4).
Make sure that the cheek pads are properly fastened
to the helmet.
4
13