NORTH STATES 8805 Manual De Instrucciones página 3

WARNING: Do not mount gate hinges into
sheetrock or plaster. Hardware is included for use
in solid materials, such as wood or metal. Never
mount the gate at the top of the stairs.
Step 2:
Position both of the preassembled wall
mounting connectors/wall hinges, vertically
so the wall hinge pins are facing upwards on
the wall, and the mounting connector is as
close to the oor as possible. Mark the top of
each wall hinge. See Figure 3.
Step 3:
Separate the mounting connectors from the
wall hinges by pressing inward on the locking
boss located in the center of the wall hinge.
Lift up on the connectors to free them from
the wall hinge. See Figure 4 for removal from
wall hinge.
Step 4:
To attach the wall hinge to the wall, align the
top with the mark drawn in Step 2. Mark the
top hole and pre-drill a 1/8" pilot hole. Attach
the top of the wall hinge in place with a screw.
Proceed down the hinge and install a screw
into each screw hole with screws provided.
Step 5:
Attach the mounting connector side A to
panel 1 by setting opening A over Pin B, push
down in order to slide Pin C into the slot of
Cylinder D. See Figure 5.
Step 6:
Attach the mounting connector side B to
panel 2 by placing Pin B at the top of panel 2
into opening A on the mounting connector
and push up so Pin C ts in slot of Cylinder D.
See Figure 6.
Step 7:
Attach the mounting connectors, that are now
attached to the panels, to the wall hinges by
aligning the horseshoe shaped hoops on one
side of the gate over the pins on the wall
hinges to set the gate in place. See Figure 7.
NOTE: Always lift up on the end panels to
ensure that the gate is properly secured and
locked in place.
FIGURE 3
Mark
Here
Wall
FIGURE 4
FIGURE 5
FIGURE 6
Opening A
Pin B
Slot in
Cylinder D
Pin C
FIGURE 7
Mark
Here
Wall
Floor
Pin C
Slot in
Cylinder D
Pin B
Opening A
Wall Hinge
Page 3