Installation And Set-Up Of The Machine; General Information; Operational And Display Elements - Komet TopVac Instrucciones De Operación

Installation and Set-up of the Machine

6 Installation and Set-up of the Machine
6.1

General Information

High voltage !
Possibility of electrical shock!

Water and Steam jet must be kept away.

Use only accepted plugs.

Check that the details on the type label on the machine correspond
with the electrical connection at the operating site for the machine.

The machine may not be connected in the event of any deviations.

Only have work carried out on the electric power supply by a
qualified electrician.
Warning !

Place the machine out of reach from children.

The machine should not block emergency exits

Overheating and fire danger!
Keep ventilation holes free.

Do not place the machine near inflammable or combustive
elements.
Notice !

Do not place the machine over or near a heating surface.

Vacuum pump can be damaged if machine is operated with a
surrounding temperature < 10° C. Use oil with a lower viscosity.
The surrounding has to be dry and well ventilated. Please use the standards for
environment conditions cited in chapter 5: "Technical Data".

The machine has to be placed in a horizontal, safe and even balancing position.

Remove all safety materials used for transportation (for example: protective foam).

Check vacuum pump oil level. If necessary fill in oil. Proceed as described in
chapter 8.1 "Maintenance".

Plug in the main electrical supply plug to the power connection.
Operating Instructions - Translation
6.2

Operational and Display Elements

Control board with vacuum gauge
Main switch is used to turn on and off the machine

Switch machine on: press the ON key.
Cover open:  VAC and TEMP digits are illuminated.
Cover closed: The digits are flashing.

Turn machine off: press the OFF key,  the VAC and TEMP digits will turn off.
Important !

When turning off the machine, wait approx. 5 seconds before
turning it on again. This allows the control system to reset and
function correctly.
19 04 272 - 01.01.2012
Eng - 9/20