In Situ Monitor Usability Test; Power Supply And Replacing The Batteries - Nonny BM-03 Instrucciones De Uso

Idiomas disponibles

EN | Baby breathing monitor

IN SITU MONITOR USABILITY TEST

We recommend performing the usability test daily, but at least when

changing the location of the bed or monitor.

• Make sure the green light ﬂashes while the baby is in the cot. The green light reacts

by ﬂashing with the baby's breathing or movements. The ﬂashing of the light may

not be regular - the frequency corresponds to the baby's movements or breaths.

• Then take the baby out of the cot and move away from the cot. Wait a while for the

vibrations from your movements and the mattress to subside.

• If a pre-alarm sounds after 17 secs and an alarm after 20 secs, the monitor has

passed the usability test and can be fully relied upon. Verify that the alarm sound

can be heard in all areas where the parents or other caregivers are present.

If the green light ﬂashes even when the baby is not in the crib, the

monitor is detecting disturbance in the surroundings. Surrounding

shocks or vibrations with a similar frequency can be falsely evaluated

by the device as the baby's breathing / movements, therefore they

must be eliminated in order to ensure the device works reliably and

the baby is safe! Disturbance can be caused by intense airﬂow

(fans, air conditioning), walking near the bed, mechanical vibration

from household appliances, etc. Eliminate disturbance in the

surroundings or relocate the cot!

The device is powered by two alkaline 1.5 V/AA batteries and monitors their power.

The device distinguishes between low and critical battery level.

Low battery is indicated by a ﬂashing red light with a picture of a battery. All

functions except the lamp are retained. The low battery indication lasts for about 2

weeks before the batteries are completely empty, so you have enough time to replace

them. The batteries must be replaced as soon as possible after the red low battery

indicator comes on.

In the event of a critically low battery, the fault is indicated audibly during the

automatic test and the device does not turn on. Replace both batteries immediately!

The batteries need changing depending on the intensity of use - usually after 4-12

months. Before replacing the batteries, switch off the device by pressing

the mechanical button. Remove the battery cover and remove the original batteries.

Remove the batteries when you are not using the monitor at all.

MXA51105

Tabla de Contenido