Sensor Pad - Nonny BM-03 Instrucciones De Uso

6.

SENSOR PAD

The sensor pad is included in the package. It can also be bought separately as a spare
part labelled BM-03D.
One sensor pad is enough until the baby is about 6 months old. If the baby starts to
climb or move in the cot, the monitored area can be enlarged by attaching a second
sensor pad. The control unit contains 2 sockets for connecting the sensor pads. The
sockets are identical, so the connector can be connected to either of them in any order.
The device will not be in active mode until at least one BM-03D sensor pad
is connected.
If any sensor pad is disconnected in active mode, the alarm is sounded immediately.
If the pad is disconnected in standby mode, a warning beep will sound and the red light
around the mechanical button will fl ash 3 times.
It is best to buy a set of 2 pads. The second pad can be used in multiple places in the
baby's fi rst months of life - for example, in another bed, at its grandparents, etc. In this
case, only the control unit is moved. When the baby grows up, the second pad can
be attached to the baby's cot together with the original pad.
Both pads are connected to the sockets on the bottom of the control unit. Always keep
loose cables or loops out of reach of the baby.
Fig. 14 Connecting two sensor
pads to the control unit
To monitor twins, a separate breathing monitor is needed for each
baby - so it is not possible to use the same control unit for 2 babies
at the same time, even though each will lie on its own mat. To use the
breathing monitor effectively, babies must always lie in their own cot,
otherwise the monitor may detect the other baby's movements.
Fig. 15 Using two sensor pads
13
MXA51105