Monitoring Room Temperature; Day And Night Mode - Nonny BM-03 Instrucciones De Uso

Switching the light on and off
The light is switched on and off using the capacitive
switch located below the NANNY logo (symbol no. 3
in Fig. 3). The light is switched on and off by touching
the light's capacitive switch which is located in the middle
of the NANNY logo. Place your fingertip on the center
of the NANNY logo and leave it attached for at least 1
second (Fig. 5b). There is no need to press the switch, just
place your finger on the surface.
The light is on for a period of 30 secs. If you place your
finger on the capacitive switch again within 20 seconds
of switching on, the lamp goes out.
After 20 secs, the lamp will gradually dim. If you place
your finger on the capacitive switch again as it dims,
the light will be restored for another 30 secs, otherwise
it will go out after 30 secs.
If the alarm is triggered in night mode, the lamp will turn
on automatically.
2.2.3

MONITORING ROOM TEMPERATURE

The control unit is equipped with a temperature sensor to measure the quality of
the environment. It serves to indicate the room is overheating, which may be one of
the causes of sudden infant death syndrome. The device can thus indicate a room
temperature that is quite likely uncomfortable, however, responsibility for the
temperature and quality of the environment lies with the parent or other caregiver
(monitor operator).
The temperature range is indicated by the light with the thermometer symbol flashing:
Flashing blue = the room temperature is below 16.5 °C. It is a cooler environment, but
it may be comfortable for you and your baby.
Flashing orange = room temperature is higher than 28 °C. It is advisable to reduce
it, for example by airing or turning down the heating, to prevent the baby from
overheating.
2.2.4

DAY AND NIGHT MODE

The device is equipped with an optical sensor to detect day and night, or darkness.
Thanks to this, the light diodes light up at night with a lower intensity than during the day
to ensure parents or other caregivers have a good night's rest.
Day and Night mode switches automatically.
Fig. 5b – Switching the light on
and off
9
MXA51105