Publicidad
Idiomas disponibles
Idiomas disponibles
PSS 3100 SE
5.8 Ripping
Use the following procedure when ripping after
scoring:
1.
Place the machine with the saw unit in its
starting position onto the workpiece.
The saw unit must be in front of the front
➢
edge of the workpiece.
2.
Align the machine so that the right edge of the
guide rail marks the desired cut.
3.
Set the cutting depth.
See also chapter 5.6 Cutting depth setting.
➢
4.
Set the cutting length.
See also chapter 5.7 Setting the cutting
➢
length.
5.
Use the plunge bar 4 to press the saw unit into
the cutting position until it engages with the
clamping lever 6.
6.
Set the feed speed.
See also chapter 5.4 Setting the feed
➢
speed.
7.
Switch the saw drive on by pressing the rocker
switch 3 forwards.
8.
Make the cut until the saw unit stops at the stop
slide 16.
The saw blade automatically returns from
➢
the cutting position to the home position.
01/2022
Fig. 15: Placing the machine onto the workpiece for ripping
Fig. 16: Ripping
23
Publicidad
