Base Plate - Mafell P1cc Manual De Instrucciones

P1cc
6. When inserting the new jigsaw blade, ensure
that the new blade locks into place by itself.
7. Push the clamping lever (2) back to its original
position to close it.
✓ The saw blade is changed.

4.5 Base plate

The machine is equipped with a base plate that permits precise rectangular cuts to be made.
Use the following procedure to remove the base
plate:
1. Rotate the clamping lever (5) from the horizontal
to the vertical position.
This releases the connection between the
➢
machine and the base plate.
2. Move the base plate until the pointer position on
the machine meets the notch in the base plate.
3. You can now separate machine and base plate
from each other.
Base plate removed.
✓
Use the following procedure to put the base plate
back on:
1. Ensure that the clamping lever (5) is in the
vertical position
2. Connect machine and base plate such that the
pointer on the machine and the pointer on the
plates are one above the other.
3. Move the base plate in the desired direction with
respect to the machine
4. Rotate the clamping lever (5) to the horizontal
position to fasten the base plate at the machine.
✓ Base plate mounted.
Replace the base plate with the swivel plate, which is available as a special accessory, if you want to make
precise angle cuts.
11/2021
Fig. 4: Replacing the saw blade
Fig. 5: Removing the base plate
Fig. 6: Mounting the base plate
13