Power Cord; Before Use; Using The Heater - HOMCOM 820-255V90 Manual De Montaje E Instrucciones

19. Avoid the use of an extension cord as the extension cord may overheat and cause
a risk of fire.
20. Do not use the appliance for other than its intended use.
21. Do not use outdoors. FOR INDOOR USE ONLY.
22. Do not leave the appliance unattended when switched on.
23. Do not place objects on the product or allow objects to obstruct the inlet or outlet
openings, or operate in close proximity to walls or curtains, etc. Do not cover the
unit when in operation.
24. Do not locate the heater immediately below a socket-outlet.
25. The use of attachments or accessories not recommended or sold by the product
distributor may cause personal or property hazards or injuries.
26. This product is intended for normal domestic/household use only.
27. Use this heater as described in this manual. Any other uses, not recommended
by the manufacturer, may cause fire, electric shock, or injury to persons and may
void the warranty.
LOCATION
1.The appliance should be placed with a minimum distance of 90cm away from
flammable objects (e.g. curtains), walls or other structures!
LOCATIONOCATION

POWER CORD

1.Use only an approved extension cord that is suitable for the appliance rating!
2.Do not lay the cord under a carpet. Do not lay rugs, mats or similar articles on it.
Position the cord so that it does not pose an obstruction or a tripping hazard.
3.Never pull the plug out of the socket at the cord!
4.Always disconnect the mains plug when the appliance is not in use.
Attention! The appliance may only be used for normal domestic use and not for
industrial purpose.

BEFORE USE

1. Before use, remove all packaging and inspect the appliance for any damages. If
there are appears to be any damages, please take back to place of purchase for a
replacement.
2. Ensure that all the accessories are included as per diagram above before you can
continue with the installation.
3. Ensure that the location of the heater installed is not directly under a power socket
and that a power socket is available to power the appliances for use.
4. Refer to the installation guide for further instruction.

USING THE HEATER

1.Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label on the unit.
2.When plugged in, turn on the Main power switch at the base side of unit.
3.When in Standby mode, only
Press to access the rest of the control panel.
a) Low Power: (Press POWER to switch it)
b) High Power: (Press POWER to switch it)
c) Timer: Press this repeatedly to set a period after which the heater will turn itself off
(between 0 hour to 12 hours)
on the control panel will respond to your touch.
3
EN