Publicidad
Idiomas disponibles
Idiomas disponibles
5.9 Sawing along markings
The swivel part has a tracing edge for 0° to 60°.
This tracing edge (21) corresponds to the inside
(side facing the motor) of the saw blade.
For bevel cuts, the marking can be seen through
the opening on the left side of the upper guard.
Use the following procedure to saw along markings:
1.
Hold the machine by the handles and position it such that the front part of the base plate is on the
workpiece.
2.
Position the tracing edge (21) at the marking on the workpiece.
3.
Switch on the machine.
4.
Ensure that the tracing edge (21) and the front edge of the saw blade are guided along the marking.
5.
Push the machine steadily forward in the cutting direction.
6.
Switch off the machine at the end of the cut.
✓
Sawing along markings terminated.
24
Fig. 21: Tracing edge
K85Ec / KSS80Ec 370
01/2022
Publicidad
