Descargar Imprimir esta página

Installing And Removing The Battery Pack - Craftsman CMCL060 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles


WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 
 6 
.

Installing and Removing the Battery Pack

(Fig. D)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack 
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in the
tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 
 2 
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
On/Off Switch (Fig. A)

CAUTION:
lens. Serious eye injury could result.
To turn the spotlight on, press the on/off/brightness
switch 
 3 
once for Mode 1 (high). Press the on/off/brightness
switch again for Mode 2 (low).
To turn the spotlight off, press the on/off/brightness switch
and cycle through to the off position.
Carrying and Suspending the Spotlight
(Fig. A)

CAUTION:
the VersaTrack™ hook or loop hook, do not shake
the spotlight or the object from which it hangs. Do
not hang the spotlight from any electrical wires or
anything that is not secure. Personal injury or property
damage may occur.

CAUTION:
hook or loop hook for hanging the LED spotlight. The
VersaTrack™ hook and loop hook are not intended
to support additional weight. Do not attach or hang
anything additional to the spotlight or risk of breakage
may occur.

CAUTION:
hook or loop hook to reach with or to support your
weight in any situation.
Loop Hook (Fig. F)
The light may be carried or hung by the loop hook 
not in use, the loop may be locked down.
To reduce the risk of serious
into the tool handle, align the
 1 
Do not stare into spotlight
When the spotlight hangs by
Only use the VersaTrack™
Do not use the VersaTrack™
 5 
MAINTENANCE

WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
This spot light contains no user‑serviceable parts, particularly
the LEDs.
Cleaning

WARNING:
of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always
wear ANSI Z87.1 approved eye protection when
performing this procedure.

WARNING:
harsh chemicals for cleaning the non-metallic parts
of the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into
a liquid.
Accessories

WARNING:
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be used
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact CRAFTSMAN call 1‑888‑331‑4569 .
VersaTrack™ (Fig. G)

WARNING:
personal injury, turn unit off and remove the
battery pack before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING:
personal injury, do not use a damaged VersaTrack™
hang hook or VersaTrack™ Trackwall. A damaged
VersaTrack™ hang hook or VersaTrack™ Trackwall will
not support the weight of the tool.
. When
English
To reduce the risk of serious
Blow dirt and dust out
Never use solvents or other
Since accessories, other than
To reduce the risk of serious
To reduce the risk of serious
7

Publicidad

loading