LIGHTSIDE Mirror Ball SET20 Manual De Usuario página 5

SET 20
ENGLISH
• The device should be well fixed; a free-swinging mounting is dangerous and may not
be considered!
• Don't cover any ventilation openings as this may result in overheating.
• The operator has to make sure that the safety-relating and machine-technical installa-
tions are approved by an expert before using them for the first time. The installations
should be inspected every year by a skilled person to be sure that safety is still optimal.
OPERATING INSTRUCTIONS
• Once connected to the mains the device starts running.
• Regular breaks during operation are essential to maximize the life of this device as it is
not designed for continual use.
• Do not switch the projector on and off in short time intervals as this reduces the
lamp life.
• The projectors' surface temperature may reach up to 85°C. Don't touch the housing
with bare-hands during its operation.
• Always unplug the unit when it is not used for a longer time or before replacing the
bulb or start servicing.
• In the event of serious operating problems, stop using the fixture and contact your
dealer immediately.
• Important: Never look directly into the light source! Don't use the effect in the presence
of persons su ering from epilepsy.
MAINTENANCE
• Make sure the area below the installation place is free from unwanted persons during
servicing.
• Unplug the mains cable .
During inspection the following points should be checked:
• All screws used for installing the device and any of its parts should be tightly fastened
and may not be corroded.
• Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally
free from any deformation.
• The mains cables must be in impeccable condition and should be replaced immedia-
tely when even a small problem is detected.
4