Lindy 38340-2 Manual De Usuario página 8

User Manual
Receiver Front and Rear
Power LED: Indicates Power.
ARC LED: This will illuminate green when the ARC function has been switched on.
SPDIF LED: This will illuminate green when the TosLink Out port outputs the audio signal which has been
sent from the TosLink In connection of the receiver.
Push Button switch: Push the button to switch the output audio source, for TosLink Out and 3.5mm Out.
Service: Reserved for future use.
24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connect to the transmitter or
receiver. This is only required at one side of the installation.
HDBaseT In: HDBaseT Input Port. Connect a compatible HDBaseT transmitter using a single Cat.6 or
above cable for all data signals. Please do not connect to a network port.
HDMI Out: Connect to an HDMI display.
IR In: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used is
within the direct line-of-sight of the IR Extender.
IR Out: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter in
direct line-of-sight of the equipment to be controlled.
TosLink In: Connect to a digital audio source with a TosLink (Optical) cable.
RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3-way connection for the
pass-through transmission of RS-232 commands.
Ethernet: Connect to a PC or laptop.
Audio Signal Output Switching
The push button on each unit allows for easy switching of the output audio signal source. The ARC &
TosLink LED indicate the applied source.
ARC LED TosLink LED
ON OFF
OFF ON
OFF OFF
Please Note: ARC source signal can only output audio to the TosLink and 3.5mm ports on the Tx.
The audio signal returned from the HDMI (Display Device) on receiver.
The audio signal returned from SPDIF IN on receiver.
The audio signal extracted from the transmitter.
Audio Signal Source
English