Assembly - RIDGID HD03180 Manual Del Usuario

INTRODUCTION
UNPACKING
Check all parts from carton against the Carton Contents
List.
If any parts are damaged or missing, contact
1-800-4-RIDGID (US and Canada) or by email at
info@ridgidvacs.com.
CARTON CONTENTS LIST (Fig. 1)
Key Description
A* Powerhead Assembly ........................................ 1
B* Dust Drum Assembly ........................................ 1
C* Qwik Lock™ Filter ............................................. 1
D Crevice Tool ..................................................... 1
E Dusting Brush . ................................................. 1
F Expandable Hose ............................................. 1
G Owner's Manual. ............................................... 1
* These parts come preassembled.
B*
C*
D
E
SP7126 HD03180 2022 ESF.indb 7 SP7126 HD03180 2022 ESF.indb 7

ASSEMBLY

ATTACHING AND REMOVING VACUUM HOSE
(Fig. 2)
1. To Insert Hose into Vac Inlet Port: Insert the
Expandable Hose (F) with the Locking Tab End
into the Vac Inlet Port, located on the side of the
Dust Drum (B), above the RIDGID SWEEP Label.
Push the Hose End straight into the Vac Inlet Port
until the Hose Locking Tab fully engages the Inlet
Qty
Port Ridges.
2. To Remove the Hose from the Vac Inlet Port:
Turn Vac OFF. Rotate the End of the Expandable
Hose (F) in either direction to release the Hose
Locking Tab from the Vac Inlet Port. Press the Hose
Locking Tab and pull the Hose End straight out of
the Vac Inlet Port.
Fig. 1
A*
NOTE: When using the Unit in the Vacuuming Mode,
the Side Battery Compartment Lid can be used as an Air
Diffuser by closing this Side Battery Compartment Lid.
F
G
7
(F)
SWEEP Label
Fig. 2
(B)
Inlet Port
Ridges
Vac Inlet
Port
Hose
Locking
Tab
6/2/22 11:46 AM 6/2/22 11:46 AM