GiBiDi SR302 Instrucciones Para La Instalación página 17

SR302
9 - TRANSMITTERS PROGRAMMING
THE CONTROL UNIT IS COMPATIBLE ONLY WITH THE TRANSMITTERS OF MAKO
868MHz SERIES.
Operation with ONE BUTTON
! Push the SW2 button for one second, after releasing it the control unit will emit an acoustic signal and LED
DL10 will turn on fixed;
! Push in 10 s the transmitter button you want to store as START command, a triple acoustic signal with 3 LED
DL10 flashes will show the storage has occured;
! Push in 10 s the button of the new transmitter you want to store.
! After the learning of last transmitter, wait for a double acoustic signal and LED DL10 off, showing the end of the
procedure.
Operation with TWO BUTTONS:
! Push the SW2 button for one second, after releasing it the control unit will emit an acoustic signal and LED
DL10 will turn on fixed.
! Push in 10 s the transmitter button you want to store as OPEN button, a triple acoustic signal with 3 LED DL10
flashes will show the storage has occured.
! Push in 10 s another button of the same transmitter to which you want to match the CLOSE function, a triple
acoustic signal with 3 LED DL10 flashes will show the storage has occured.
! Repeat in 10 s the sequence of buttons pushes to store a new transmitter.
! After the learning of last transmitter, wait for a double acoustic signal and LED DL10 off, showing the end of the
procedure.
NOTE: It is possible to store again a transmitter to switch from 1 button operation to 2 buttons and vice-
versa.
The double buttons mode is possible only if the 2 buttons of the transmitter are stored during the
same learning cycle, one after the other.
COMPLETE CANCELLATION OF THE MEMORY
Push Sw2 button (LED L10 is on), keep pushing it as long as LED DL10 will make 10 flashes with 10 acoustic
signals.
The transmitters buttons already stored can be over-written at any time.
It is possible to store 31 buttons or transmitters max.
17
UK
IT