End Of Cooking - Whirlpool OAKZ9 1395 P IX Guía Rápida

5. END OF COOKING

An audible signal will sound and the display will
indicate that cooking is complete.
Press to continue cooking in manual mode
(without a programmed cooking time) or turn
the adjustment knob to extend the cooking time
by setting a new duration. In both cases, the
temperature or the grill level settings will be retained.
BROWNING
Some functions of the oven enable you to brown
the surface of the food by activating the grill once
cooking is complete.
When the display shows the relevant message, if
required press to start a five-minute browning
cycle.
Once the browning function has been activated, you
can change the time for which it will run by turning
the adjustment knob. You can also stop the function
at any time by turning the selection knob to select a
different function or by turning it to
oven off.
. TIMER
When the oven is switched off, the display can be
used as a timer. To activate this function, make sure
that the oven is switched off and turn the adjustment
knob: The icon will flash on the display.
Turn the adjustment knob to set the length of time
you require and then press
timer. An audible signal will sound and the display
will indicate once the timer has finished counting
down the selected time.
Please note: The timer does not activate any of the cooking
cycles. Use the adjustment knob to change the time set on
the timer; press to switch the timer off at any time.
to switch the
again to activate the
.
KEY LOCK
To lock the keypad, press and hold
same time for at least five seconds.
Do this again to unlock the keypad.
Please note: This function can also be activated during
cooking. For safety reasons, the oven can be switched off at
any time by turning the selection knob to
. AUTOMATIC CLEANING – PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished airing)
running the Pyro cycle.
Remove all accessories - including shelf guides -
from the oven before activating the function. If the
oven is installed below a hob, make sure that all
the burners or electric hotplates are switched off
while running the selfcleaning cycle. For optimum
cleaning results, remove excessive residuals inside
the cavity and clean the inner door glass before using
the Pyro function. We recommend only running
the Pyro function if the appliance contains heavy
soiling or gives off bad odours during cooking. Turn
the selection knob to select the automatic cleaning
function.
There are two self-cleaning cycles available: a
complete cycle and a quick cycle (ECO).
Turn the adjustment knob to select the desired cycle
and press to confirm. The oven begins the self-
cleaning cycle, and the door locks automatically: a
warning message appears on the display, along with
a countdown indicating the status of the cycle in
progress.
Once the cycle has been completed, the door remains
locked until the temperature inside the oven has
returned to a safe level.
The display will then show the current time.
Please note: like with other manual, it is also possible to set
the end time for the automatic cleaning cycle.
and at the
.