Possible Misuse; Active Vibration Reduction; Lithium­iOn Battery Status Display - Hilti TE 60-A36 Manual De Instrucciones Original

3.2 Intended use
The product described is an electrically powered combihammer with pneumatic hammering mechanism. It
is designed for drilling in concrete, masonry, wood and metal. The product can also be used for light- to
medium-duty chiseling on masonry and surface finishing work on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.2.1

Possible misuse

• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment.
3.3 Undercut anchors
The product is suitable for setting undercut anchors. Use only suitable setting tools.
Detailed information on this topic can be obtained at your local Hilti Center.
3.4 ATC
The product is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the product will suddenly pivot about its own axis in the opposite direction.
ATC detects this sudden pivoting movement of the product and switches the product off immediately.
For ATC to function correctly, the product must be free to pivot.
After an ATC cut-out, switch the product off and then on again.
3.5

Active Vibration Reduction

The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.6 Quick-release chuck (accessory)
The quick-release chuck makes changing accessory tools a quick operation with no additional tools needed.
It is suitable for accessory tools with cylindrical or hexagonal shank used in the "With hammering action
mode.
3.7 Service indicator
The product is equipped with a service indicator LED.
3.7.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.7.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
*2201898*
Meaning
Servicing is due.
Have the product repaired by Hilti Service.
The product is switched on
The product is switched off because of a transient
fault.
The product is switched off.
The product is working at half power.
The product is working at full power.
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
2201898
"
English 19