Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING THE ELECTRIC BREAST PUMP
Wash and sterilize your breast pump before using. Follow instructions in section for CLEANING, STERILIZING AND MAINTENANCE.
1.
Wash your hands thoroughly before handling the pump.
2.
Make sure the silicone insert is securely attached. Clip lip over end of horn first, then push tube through funnel, ensuring lip
is fully clipped over the other side also.
3.
Push horn onto the lower pump body as far as it will go.
4.
Push diaphragm down into lower pump body as far as it will go and push diaphragm cap over the top as far as it will go until it is sealed.
5.
Push upper pump body and lower pump body together. They will click into place.
6.
Push valve onto lower pump body.
7.
It is possible for the valve to seal closed during storage & cleaning. Before each use remember to clean & squeeze the valve to open.
8.
Screw bottle onto lower pump body.
9.
Connect air tube onto upper pump body and the air tube socket of the motor unit. This is on the RIGHT of the two sockets on the motor
unit.
10. Plug the electric adaptor into the electric adaptor socket of the motor unit. This is on the LEFT.
11.
Plug the electric adaptor into the mains power supply.
QUICK START GUIDE
1
2
6
7
BATTERY OPERATION
1.
To install batteries, disconnect the air tube and electric adaptor.
2.
Push the clip of the battery compartment towards centor of motor unit while pulling upwards. Remove the cover.
3.
Insert batteries as indicated inside the battery compartment and push the cover back into place until it snaps shut.
4.
Batteries are to be inserted with the correct polarity. Ensure that the + and – ends of the batteries are positioned correctly. Requires 4AA
batteries (sold separately).
QUICK START GUIDE
1
DO NOT USE RECHARGEABLE BATTERIES.
The use of rechargeable batteries could cause your breast pump to malfunction and will void the warranty. Different types of batteries or new
and used batteries are not to be mixed. Only batteries of the same or equivalent type as recommended are to be used. Exhausted batteries are
to be removed from the breast pump. Batteries should always be removed or replaced by an adult. Keep away from children. Remove batteries
if the electric breast pump will not be used for some time. Help the environment by disposing of your product responsibly. The product and
batteries must not be disposed of in the domestic waste as they contain substances which can be damaging to the environment and health.
Please use designated collection points or recycling facilities when disposing of the item or batteries.Users must replace the 4 AA batteries
regularly; or use the recommended Mains Adaptor (PSU) S01513A EBP (522662) conforms to the requirements of IEC 60601-1-2 (EMC).
Adaptor (S01513A) conforms to the requirement of UL 60601-1 and certified to CAN/CSA-C22.2 No.601.1
All manuals and user guides at all-guides.com
3
8
9
4
10
5
11
Publicidad
